Structural Drying in the United States

Room by room, it is drying the building itself instead of the contents and surfaces. After you describe the problem, that means framing lumber, wall cavities, subfloor, joists, plaster, masonry and slabs.

After you describe the problem, usually yes. Room by room, framing tolerates short term wetting well and dries back to normal moisture content with proper airflow.

After you describe the problem, often not: most wall cavities dry through small hidden access, and on a structural recovery plan we cut only where the gypsum has crumbled, delaminated or been contaminated.

For a practical next step, wet fiberglass insulation does, because it holds water and will not dry at a useful rate inside a closed cavity.

For a practical next step, it is a temporary sealed space around the wet part of the building, usually plastic sheeting taped to existing walls.

For a practical next step, it rates the drying load, meaning how much of the total surface area of a space is wet porous material.

Room by room, framing and subfloor commonly reach target in four to seven days. Room by room, plaster and lath, concrete slabs and multi layer floor assemblies can run ten days or longer.